DESCRIPTIONS
10 pair Krone LSA Plus disconnection module (TP-1201-10) is used throughout the distribution level, in the main distribution frames (MDF), in the cross connection cabinets (CCC) or in the distribution point (DP) boxes. It is highly reliable and cost-effective wire connection system for modern telecommunications and data networks.
It adopts IDC (Insulation Displacement Connection) technique, which means no soldering, wire-stripping or the use of screws, and which clamps the wires at a 45 degree angle, thus dramatically reducing the risk of a poor termination and increasing the wiring productivity. Contacts that ensure the highest degree of reliability even under the most adverse environmental and climatic conditions. A completely reliable, gas-tight connection between the contact and conductor.
10 pairs LSA disconnection modules use a normally closed two piece contact, with a convenient disconnection feature. By inserting a disconnect plug into a wire pair, you can temporarily or permanently disconnect the circuit. A test cord can be inserted into a pair to test each side of the circuit independently. This greatly accelerates fault identification. The center contact point can also be used for overvoltage or current protection.
MAIN FEATURES
- Insulation Displacement Connection
- No wire-stripping, screw and solder free
- Reliable connections
- Clear labeling
- Modular design and installations
- Gas tight connection
- One push wire insertion
- Robust long-term environmental stability
- Flexible indoor and outdoor use
TECHNICAL PARAMETERS
|
General
|
|
|
Storage Temperature:
|
-40°C ~ +80°C
|
|
Operating Temperature:
|
-20°C~+60°C
|
|
Relative Humidity:
|
≤93% non-condensing
|
|
|
|
|
Apperance
|
Uniform color, W/O crusting and cracks
|
|
|
|
|
Materials
|
|
|
Plastic:
|
Thermoplastic ABS
|
|
Flame Retardant:
|
Not Flame-retardant or UL 94V-0
|
|
Contact:
|
Special brass
|
|
Coating:
|
0.5μm silver or nickel plating
|
|
|
|
|
Specifications
|
|
|
Insulation Resistance:
|
> 50 GΩ @ 500 V
|
|
Dielectric Strength:
|
> 2000Vrms
|
|
Contact Resistance:
|
1 mΩ (Typical)
|
|
Conductor Diameter:
|
0.4mm-0.8mm
|
|
Insulation Diameter:
|
0.7mm-1.60mm
|
|
Gas Tight Performance:
|
> 50% @ Each side
|
|
Pulling Strength:
|
> 25N @ Vertical side
|
|
Life Cycles:
|
> 200 Times
|
ORDER DATA
|
Item No
|
Descriptions
|
|
TP-1201-10
|
10 pairs LSA disconnection module
|
